Loading...
News Article

Semiconductor breakthrough overcomes solar energy challenge

News
Oxford University-led team shows how bismuth sulphide could enable more efficient solar panels with higher outputs

A study led by the University of Oxford has identified a novel compound semiconductor that overcomes a key limitation with light-harvesting materials. The results published on 28 October in Nature, could enable more efficient solar panels with higher outputs.

Solar energy currently faces a critical limitation: materials that absorb light more strongly also tend to be less efficient at turning captured light into electricity.

In the new study, 'Delayed electron–hole recombination in a pseudo-direct semiconductor'. the researchers discovered that the compound semiconductor bismuth sulphide (Bi₂S₃) appears to side-step this trade-off. This is because it has an unusual arrangement of energy levels that allows it to absorb light strongly while losing its electrical charges more slowly, pointing to a new way to design more efficient solar cells.

“One of the longstanding challenges in developing efficient solar-energy materials is that the properties which make a semiconductor very good at absorbing sunlight also tend to make the resulting electrical charges disappear quickly,” said corresponding author Laura Herz (professor in the Department of Physics, University of Oxford, pictured above). “Our work shows that this trade-off is not inevitable. By uncovering how an unusual electronic structure can combine strong light absorption with much slower recombination, we have identified a new principle for designing semiconductors that could help us harvest solar energy more efficiently.”

The team excited thin films of Bi₂S₃ with extremely short laser pulses and then measured how quickly the resulting charges disappeared, using a technique called ultrafast terahertz spectroscopy. They carried out the measurements at temperatures ranging from room temperature to just above absolute zero.

Electronic structure calculations by Marina Filip’s group in the Department of Physics revealed what makes the material unusual. It absorbs light mainly through one strong route between energy levels, but just below this in energy lies a second, much weaker route, through which charges are lost only slowly. The two are so close in energy that charges spend much of their time in these lower-energy states, which act as a temporary ‘reservoir’ and slow their loss.

The experiments confirmed this picture. In most semiconductors, charges are lost faster as the material is cooled, but in Bi₂S₃ they were lost more slowly, as more charges settled into the reservoir. This matched the team’s model of what physicists call a pseudo-direct semiconductor. The team estimates that, at room temperature, this arrangement cuts the rate at which charges are lost by about 75 percent compared with conventional materials that absorb light as strongly.

“What makes this discovery particularly exciting is that we are not simply improving an existing semiconductor property but identifying a different way in which semiconductors can behave,” said Herz. “Understanding this mechanism gives us a roadmap for discovering and potentially engineering other materials with similarly advantageous properties.”

For solar energy, this could matter in two ways. Charges that last longer have more chance of being collected, which could reduce one of the fundamental energy losses in solar cells without sacrificing strong light absorption. Longer-lived charges could also allow more time for the chemical reactions needed to turn sunlight into fuels.

The team’s calculations suggest that other materials with the same property could be found by screening materials databases, or engineered. The researchers stress that the study demonstrates a physical mechanism rather than a finished solar cell. Further work is now needed to translate these findings into improved solar cell technologies.

The research was an international collaboration between the University of Oxford and Wuhan University in China. The research was funded by the UK Engineering and Physical Sciences Research Council (EPSRC), with additional support from the Italian Ministry of University and Research and Oxford Photovoltaics.

Logo
x