Qorvo uses NI AWR software to design GaN power amplifier

Qorvo, a developer of RF systems and solutions for wireless and broadband communications, has recently used NI's AWR Design Environment to meet the requirements for a GaN-based power amplifier with high output power, wide bandwidth, and high efficiency.
Many modern microwave electronic systems specify amplifiers with high output power, wide bandwidth, and high efficiency. Until recently, most wideband high-power amplifier (PA) solutions have relied on vacuum electronics-based technologies. Recent work, however, shows steady progress in realising high-power, high-frequency, wideband amplifiers using GaN monolithic microwave integrated circuit (MMIC) technology that operates from near DC up to 7 GHz.
The Qorvo team used NI AWR Design Environment to develop a 1 to 8 GHz PA MMIC fabricated with a 0.15µm GaN process technology. The process featured a 100 μm thick SiC substrate and compact transistor layouts with individual source grounding vias (ISVs). The design used a non-uniform distributed PA (NDPA) topology with a novel trifilar connected output transformer.
Design goals for PA MMIC were: 1 to 8 GHz bandwidth, > 25 dB small signal gain, 10 W saturated output power, and power-added efficiency (PAE) exceeding 30 percent. A small-signal gain goal in excess of 25 dB required at least two amplification stages.
The resultant two-stage amplifier demonstrated 9.3 to 13.1W of output power over a 1 to 8GHz bandwidth with greater than 29 percent associated PAE. Theoretically transformation ratios up to 2.25:1 are possible depending on the location of the output tap. Due to physical limitations regarding the location of the low impedance side tap, the microstrip implementation produced a ratio closer to 2:1.
According to the company, the performance of the PA compared favourably to recently published GaN MMIC PA benchmark results for bandwidth, gain, die size, and efficiency. It says that the success of this project was due to the powerful circuit design capabilities of Microwave Office software combined with integrated AXIEM 3D planar electromagnetic simulation.
Secure Your Hydrogen Supply
A study supply of high-purity hydrogen is critical to semiconductor fabrication. Supply chain interruptions are challenging manufacturers, leading to production slowdowns and stoppages. On-site hydrogen generation offers a scalable alternative for new and existing fabs, freeing the operator from dependence on delivered gas.Plant managers understand the critical role that hydrogen plays in semiconductor fabrication. That important job includes crystal growth, carrier gas, wafer annealing, and in the emerging Extreme UV Lithography (EUV) that will enable new generations of devices. As the vast need for semiconductors grows across all sectors of world economies, so does the need for high-purity hydrogen.
Take control with Nel on-site hydrogen generation.
Read more