Towards better solar cells
The bulk photovoltaic (BPV) effect is an uncommon phenomenon that may enable certain materials to outperform the conventional p–n junctions used in solar cells. In a recent study, researchers from Japan demonstrated the BPV effect in alpha-phase indium selenide α-In2Se3 for the first time along the out-of-plane direction, validating previous theoretical predictions.
They say the conversion efficiency recorded in their α-In2Se3device signals a promising advancement for future solar cell technologies and photosensors.
Today, most solar cells employ p–n junctions, leveraging the photovoltaic effect that occurs at the interface of different materials. However, such designs are constrained by the Shockley–Queisser limit, which puts a hard cap on their theoretical maximum solar conversion efficiency and imposes a tradeoff between the voltage and current that can be produced via the photovoltaic effect.
However, certain crystalline materials exhibit an intriguing phenomenon known as the bulk photovoltaic (BPV) effect. In materials lacking internal symmetry, electrons excited by light can move coherently in a specific direction instead of returning to their original positions. This results in what is known as 'shift currents' leading to the generation of the BPV effect. Although experts have predicted α-In2Se to be a possible candidate to demonstrate this phenomenon, it hasn’t yet been experimentally investigated.
To fill this knowledge gap, a research team from Japan led by Noriyuki Urakami, an associate professor from Shinshu University, set out to explore the BPV effect in α-In2Se3. Their findings were published in Volume 125, Issue 7 of Applied Physics Letters 2024 .
“This material has recently become a hot topic in the field of condensed matter physics, as it might be able to generate a shift current. Our study is the first to experimentally demonstrate this prediction,” says Urakami.
First, the researchers produced a layered device composed of a thin α-In2Se3 layer sandwiched between two transparent graphite layers. These graphite layers served as electrodes and were connected to a voltage source and an ammeter to measure any generated currents upon light irradiation. Notably, the team employed this specific arrangement of layers because they focused on the shift currents occurring in the out-of-plane direction in the α-In2Se3 layer.
After testing with different external voltages and incident light of various frequencies, the researchers verified the existence of shift currents in the out-of-plane direction, confirming the above mentioned predictions. The BPV effect occurred throughout a wide range of light frequencies.
Most importantly, the researchers gauged the potential of the BPV effect in α-In2Se3 and compared it to that in other materials. “Our α-In2Se3 device demonstrated a quantum efficiency several orders of magnitude higher than other ferroelectric materials, and a comparable one to that of low-dimensional materials with enhanced electric polarisation,” remarks Urakami. He adds, “This discovery will guide material selection for the development of functional photovoltaic devices in the near future.”
The research team is hopeful that their efforts will eventually have a positive environmental impact by contributing to the field of renewable energy generation. “Our findings have the potential to further accelerate the spread of solar cells, one of the key technologies for environmental energy harvesting and a promising avenue towards a carbon neutral society,” concludes Urakami.
The team hopes the study will paves the way for further studies to harness the BVP effect and vastly improve the performance of solar cells, as well as enhance the design of sensitive photodetectors.
